Predator offer cues ranging from 18 to 21oz. There are rare occasions where the wood species used in a cue will not allow the cue to weigh 18oz - 21oz. If this occurs Manning will contact you prior to shipping. Predator Cues utilize a stackable weight system so your cue may include one or more weight bolts within the butt of the cue to weigh the cue to your specific request. Additional Predator weight bolts are available by clicking the title below:

Predator Weight Bolts

The Original Uni-Loc® 

• Our one-turn-on, one-turn-off joint system
• Concentric design with 360°of equal pressure around the joint
• 30 times more accurate than a standard joint
• Patented design
• 100% interchangeability with other shafts and butts containing the original Uni-Loc joint

Joint Protectors safely secure the joint of your cue when broken down into 2 pieces. Protect the only moving part of your cue from accidental side pressure, keeping your pin straight preserving the cues accuracy and straightness. The shaft protector keeps the joint clean of debris that can accumulate over time which can cause damage to the pin and cause the cue to bind together. An inexpensive safe way to protect your cue.

Uni-Loc® Weight Cartridge Kit

The Uni-Loc® Weight Cartridge Kit lets you fine-tune the weight of your cue within a tenth of a ounce. Eight different weights, ranging from 0.1 oz. to 2 oz., give you up to 30 possible weight combinations for unmatched precision. The versatile installation tool has dual prongs that interlock with each weight and a detachable handle. The tool can be used with the handle for easy on-the-go tuning, or with a drill bit for lightning fast tuning at home.

Weight sizes: 0.1, 0.2, 0.3, 0.4, 0.5, 0.7, 1, 2 oz.

Predator QR-2 Pool Cue Extensions

The Predator QR Pool Cue Extensions pair with any Predator Cue equipped with the Uni-Loc® Weight Cartridge System. Once installed the quick releasing extension adds additional butt length with a single turn of the extension handle. Simply remove your existing rubber bumper, install the Uni-Loc® QR Extension2 bumper using a standard 6mm allen wrench, twist on the QR Extension2 handle and you’re ready to go. Available in 3-inch, 8-inch, or 12-inch length.